FLIR Ranger HRC MS - Adjustment Mode

Ranger HRC™ operator´s manual – System operation
140 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
External NUC against lens cover
Step Action
1
Press the FCN + NUC buttons < 1
second to perform an External NUC against the lens
cover.
NOTE: If the default setting for the NUC button has been changed (Setup- Image
dialog box, see section 7.6.1.1), the FCN + NUC buttons shall be pressed > 1
second to perform an External NUC against the lens cover.
External NUC against scene
Step Action
1 Direct the camera towards a surface with an even temperature. The temperature of the
reference surface shall preferably be the same as the temperature of the target. A clear
sky can, even if it is cold, be used as an acceptable reference surface.
Press the
C + NUC buttons < 1 second to perform an External NUC against the scene.
NOTE: If the default setting for the NUC button has been changed (Setup- Image
dialog box, see section 7.6.1.1), the
C + NUC buttons shall be pressed > 1 se-
cond to perform an Internal NUC.
11.3.2 Adjustment mode
There are ve combinations of Adjustment mode and Color Distribution
mode selectable via the System Software menu system.
Manual: Manual adjustment of level and span.
Auto linear): Automatic adjustment of level and span, with color
distribution in Linear mode.
Auto full): Automatic adjustment of level and span, with color distri-
bution in Histogram mode.
DDE linear): Automatic adjustment of level and span, with color
distribution in Linear mode and with digital enhancement of details
in the scene.
DDE full): Automatic adjustment of level and span, with color distri-
bution in Histogram mode and with digital enhancement of details in
the scene.