7.2 Menu system
The System Software menu system gives access to the system features.
The menu system is displayed when the system is in MENU mode. The
MENU mode is entered by pressing the ENTER button on the Joystick
Control Unit (JCU).
When the system is in MENU mode, a menu bar is displayed in the top
of the monitor, with the currently selected menu and feature highlighted.
The menu options are somewhat different depending on if IR or TV is
selected.
Figure 7.2 Menu bar with Pan/Tilt menu selected.
Features that directly perform an action are displayed as a command, for
example Start autoscan in the gure above. Features that open up a dia-
log box are displayed with three dots after the feature title, for example
Go to position…. Features that currently are disabled and not available
for selection are shaded in the menu.
7.2.1 Navigation in menu system
The Joystick Control Unit JCU) is used to navigate in the menu system
and to execute actions.
The UP/DOWN/LEFT/RIGHT keypad buttons are used to navigate
in the menu system. The keypad buttons are also used to select fea-
tures and to enter values.
To Next Page
Loading...
