FLIR Ranger HRC MS - 12.2.12 Zoom Interpolation

Ranger HRC™ operator´s manual – Optimizing the IR Image
184 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
As an alternative to using the JCU as described above, the IR Camera
menu system can be used:
Inverting Palette
Step Action
1 Select Setup/IR menu to open the IR Camera menu system.
2 Select Image/Invert palette.
3 Press the ENTER button to invert the palette.
4 Press the CANCEL button to exit the IR Camera menu system.
12.2.12 Zoom interpolation
Zoom interpolation is a function that has effect when the digital zoom is
used, see section 5.2.10.
The default setting of Zoom interpolation is On.
Selecting Zoom interpolation On/Off
Step Action
1 Select Setup/IR menu to open the IR Camera menu system.
2 Select Image/Zoom…/Digital Zoom/Factor.
3 Use the LEFT/RIGHT buttons to zoom to the desired position.
4 Press the ENTER button to conrm.
5 Press the ENTER button to re-open the IR Camera menu system.
6 Select Setup/Image…/Zoom interpolation.
7 Use the LEFT/RIGHT navigation buttons to select On or Off.
8 Press the ENTER button to conrm.
9 Press the CANCEL button to exit the IR Camera menu system.