FLIR Ranger HRC MS - Access Code; Save Settings; Factory Default; Tools Menu

Ranger HRC™ operator´s manual – IR Camera software
Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008 101
8.3.3.10 Access code
Figure 8.13 Access code dialog box.
This dialog box species the access code. To enter a new access code, use
the navigation pad to change the values and press the ENTER button to
conrm the new code.
8.3.3.11 Save settings
By selecting Save settings, the current system settings will be saved,
and loaded when the camera is switched on the next time.
8.3.3.12 Factory default
By selecting Factory default, all camera settings are reset to the factory
settings.
8.3.4 Tools menu
NOTE: The rst time you are entering the Tools menu, you will have to enter an access
code. The default code is 0000. The code will prevent non-authorized personnel from
changing the camera settings. To change the access code, see section 8.3.3.10 – Access
code.
Figure 8.14 Tools menu.