FLIR Ranger HRC MS - System components

Ranger HRC™ operator´s manual – Hardware installation
110 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
9.2.2 System components
The Ranger HRC MS system can be congured for stand-alone opera-
tion or for operation in an IP network with multiple systems. Cable con-
nections for three typical stand-alone congurations are described in the
sections below.
NOTE: The control of the video channels (TV and IR) is dened via a setting in the System
Software. The recommended setting depends on the number of connected video moni
-
tors. For detailed instructions, see section 10.1.
For information about connections in an IP network conguration, see
section 15.9.