Ranger HRC™ operator´s manual – System operation
136 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
11.1.3 Remote power control
The JCU can be used to remotely control the power. If the system is equip-
ped with a Remote Power Controller unit, the entire system will be turned
on/off. Otherwise, the IR and TV cameras and the LRF, DMC and GPS
units will be turned on/off.
NOTE: The Power Box or Power Supply unit has to be turned on; otherwise it is not pos-
sible to use the remote power control function.
Remotely turning power on
Step Action
1 Press and hold down the FCN button.
2 While the FCN button is held down, press and hold down the ENTER button for more
than 3 seconds to turn on the power.
Remotely turning power off
Step Action
1 Press and hold down the FCN button.
2 While the FCN button is held down, press and hold down the FRZ button for more than
3 seconds to initiate the power off command.
NOTE: The system will be parked before the power off command is executed,
which typically means that the power is turned off after 10 seconds.
To Next Page
Loading...
