FLIR Ranger HRC MS - Select scene

Ranger HRC™ operator´s manual – Optimizing the IR Image
Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008 161
12.1.2 Select scene
The camera uses the scene as viewed on the monitor as basis for image
adjustments. The target scene, including zooming and focusing, shall be
selected before adjustments are made to optimize the image.
12.1.2.1 Optical zoom
Optical zooming
Step ORIGINAL setting ALTERNATIVE setting
1 Use the joystick to direct the camera towards the target scene.
2
Press button
to zoom in.
Press button
to zoom out.
Turn the joystick collar to the left to
zoom out.
Turn the joystick collar to the right to
zoom in.
As an alternative to using the JCU as described above, the IR Camera
menu system can be used:
Optical zooming
Step Action
1 Press the ENTER button to enter MENU mode.
2 Select IR menu from the Setup menu and press the ENTER button. The menu system
of the IR Camera is opened.
3 Select Image and press the ENTER button.
4 Select Zoom… and press the ENTER button. The Zoom dialog box is displayed.
5 Select Zoom.
6 Use the LEFT/RIGHT navigation buttons to zoom continuously in/out.
7 Press the ENTER button to conrm.
8 Press the CANCEL button to exit the IR Camera menu system.