FLIR Ranger HRC MS - Things to Consider; To Consider When Auto Focusing

Ranger HRC™ operator´s manual – IR Camera software
90 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
Menu choice Possible choices Explanation
Adjust image...
(continue)
If
Level and Histogram or Linear are
selected in the Image setup dialog box, you
can change span and brightness by using the
navigation pad.You can also carry out an one-
shot autoadjust maneuver.
Palette... • Rainbow
• Rainbow HC
• Gray (white hot)
• Iron
Use the navigation pad to select different IR
palettes.
Press the ENTER button to conrm.
Invert Palette – Press the ENTER button to invert the current
palette
Hide graphics
Show graphics
– When graphics are hidden, this command will
be Show graphics.
8.3.1.1 To consider when auto focusing
To make it possible for the camera to auto focus properly; there are a few
things to consider.
• The default area that the camera uses when auto focusing is a 80×60
pixel box, centered vertically and horizontally on the screen.
• The camera will have difculties auto focusing when the image has
low contrasts between different areas.
• Keep the camera steady when auto focusing.