Ranger HRC™ operator´s manual – System software
Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008 71
7.6.1.6 Setup – Maintenance
The Setup – Maintenance dialog box is used to dene system constants.
The Setup – Maintenance dialog box is the same for IR and TV.
Figure 7.24 Setup – Maintenance dialog box.
If a password other than the default system value 0000 has been set, the
Enter password dialog box will appear before the Setup – Maintenance
dialog box is opened. See section 7.6.1.6.1.
Setup – Maintenance dialog box
Feature Description
Run diag tool The Run diag tool feature is used to start the diagnostic test.
• Yes: Opens the Setup – Diag tool dialog box, see section 15.7.
• No: No action.
To Next Page
Loading...
