Ranger HRC™ operator´s manual – Joystick Control Unit
Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008 41
JCU joystick and keypad – MENU mode
Feature Description
NUC Press the NUC button < 1
second
to perform an Internal NUC.
Press the
NUC button > 1
second
to perform a one-shot auto focus adjustment.
Press the
FCN + NUC buttons < 1
second
to perform an External NUC against the
lens cover.
Press the
FCN + NUC buttons > 1
second
to go to the xed focus position.
Press the
C + NUC buttons < 1
second
to perform an External NUC against the
scene.
Press the
C + NUC buttons > 1
second
to perform a one-shot auto focus
adjustment.
NOTE: The default behavior (above) of the NUC, FCN + NUC and C + NUC but-
tons can be inverted in the Setup- Image dialog box, see section 7.6.1.1.
6.2.6 PROG POSITION mode
The PROG POSITION mode is entered by pressing the FCN button in
AUTOSCAN mode. The PROG POSITION mode can also be entered from
the System Software menu system.
NOTE: For full functionality of the JCU when programming autoscan points, the MMI
Control mode in the Setup – Maintenance dialog box shall be set to Original, see section
7.6.1.6.
JCU joystick and keypad – PROG POSITION mode
Feature Description
Joystick Move the joystick to the left/right to pan the system left/right.
Move the joystick forwards/backwards to tilt the system up/down.
Joystick
collar
Turn the joystick collar to the left/right to focus near/far.
Joystick
button
Press the joystick button < 1
second
to go to the next eld-of-view.
Press the joystick button > 1
second
toggle between Slave mode on/off, see
section 7.5.1.
FCN Press the FCN button to open the Edit pos # dialog box, see section 7.4.1.2.2.
SCN No function in PROG POSITION mode.
ID Reserved for future capabilities.
TV/IR Press the TV/IR button to toggle between TV imaging and IR imaging.
To Next Page
Loading...
