Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008 83
8
IR Camera software
The IR Camera software is used to control the IR Camera directly. The
IR Camera menu system gives access to all the functions that are used to
control the IR image quality. The software also provides the operator with
information about the IR Camera.
For most operators, the features for control of the IR image that are avail-
able via the System Software menu system and the Joystick Control Unit
JCU) are fully sufcient, see section 11.3.
8.1 IR Camera information
Information from the IR Camera can be displayed on top of the IR image
on the monitor. In the GUI Setup dialog box it is possible to select which
information to display on the monitor, see section 8.3.3.2.
NOTE: When the IR Camera menu system is not opened, the IR Camera information
in the bottom line is hidden behind the system information displayed by the System
Software.
Figure 8.1 IR Camera information.
To Next Page
Loading...
