FLIR Ranger HRC MS - Go to Position; Current Position List

Ranger HRC™ operator´s manual – System software
50 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
7.4.1.1 Go to position
The Go to position dialog box is used to move the system to the position
of the selected autoscan point 1 to 32).
It is possible to select also autoscan points that are dened as inactive in the
Route sequence dialog box, see section 7.4.1.3. An inactive autoscan point
is still available, but it is excluded from the autoscan route sequence.)
Figure 7.6 Go to position dialog box.
Go to position dialog box
Feature Description
Number The Number feature is used to select autoscan point.
7.4.1.2 Current position list
The Current position list dialog box is used to append autoscan points to
the current autoscan list and to dene new autoscan lists.
If no current position list exists, the New pos # dialog box is opened directly,
see section 7.4.1.2.1.
Figure 7.7 Current position list dialog box.
Current position list dialog box
Feature Description
Append The Append feature is used to append new autoscan points to the current
autoscan list. The procedure for appending autoscan points is described in
section 11.4.
New The New feature is used to create a new autoscan list. The procedure for
creating autoscan lists is described in section 11.4.
NOTE: When New is selected, the current autoscan list is replaced.
To save the current list before
New is selected, see section 11.4.2.7.