FLIR Ranger HRC MS - Example

Ranger HRC™ operator´s manual – System software
Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008 47
The ENTER button is used to activate selected features and to con-
rm actions.
The CANCEL button is used to exit without changing.
The functions of the keypad buttons in MENU mode are described more
in detail in section 6.2.5.
7.2.1.1 Example
The example below describes how the JCU is used in the menu system to
select which autoscan point the system shall be moved to.
Figure 7.3 Pan/Tilt menu and Go to position dialog box.
Example
Step Action
1 Press the ENTER button to enter MENU mode.
2 Use the LEFT/RIGHT navigation buttons to select Pan/Tilt in the Main menu.
3 In the Pan/Tilt menu, use the UP/DOWN navigation buttons to select Go to position….
Press the ENTER button. The Go to position dialog box will be displayed.
4 Use the LEFT/RIGHT navigation buttons to decrease/increase the autoscan point position
number.
5 Press the ENTER button to select the displayed position. The system will exit MENU
mode and the system will move to the selected position.