FLIR Ranger HRC MS - LRF Mode; MENU Mode; PROG POSITION Mode

Ranger HRC™ operator´s manual – Functions and features
24 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
5.1.4 LRF mode
When the system is in LRF mode, the Laser Range Finder (LRF) unit is
active and can be used to measure the distance to a target.
For instructions on how to measure distances with the LRF unit, see sec-
tion 11.5.
LRF mode is entered by pressing the FCN + INV buttons simultaneously
in NORMAL mode or by selecting the Activate laser feature in the LRF
menu.
When the system is in LRF mode, “Laser ready”, “Laser charging” or
“Laser not ready” is displayed in the upper left corner of the monitor.
5.1.5 MENU mode
When the system is in MENU mode, the menu system of the System Soft-
ware is displayed, which gives access to the features of the system. The
JCU is used to navigate in the menu system and to execute actions.
MENU mode is entered by pressing the ENTER button in NORMAL or
PARK mode.
5.1.6 PROG POSITION mode
When the system is in PROG POSITION mode, new autoscan points can
be dened and existing points can be edited.
For instructions on how to dene and edit autoscan points, see section
11.4.
PROG POSITION mode is entered by pressing the FCN button in AUTO-
SCAN mode or via the Go to position…feature in the Pan/Tilt menu.
When the system is in PROG POSITION mode, “Prog position” is dis-
played in the upper left corner of the monitor.