FLIR Ranger HRC MS - IR;TV Video Swap Setting; Joystick Control Unit Settings; Original or Alternative Setting

Ranger HRC™ operator´s manual – Basic settings
Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008 125
10.1.3 IR/TV video swap setting
IR/TV video swap setting
Step Action
1 Press the ENTER button to enter MENU mode.
2 Select Maintenance …from the Setup menu and press the ENTER button. The Setup
– Maintenance dialog box is displayed.
3 Select IR/TV video swap.
4 a If one video monitor is connected, use the LEFT/RIGHT navigation buttons to select
Yes.
4 b If two video monitors are connected, use the LEFT/RIGHT navigation buttons to select
No.
5 Press the ENTER button to conrm and to exit MENU mode.
10.2 Joystick Control Unit settings
The functionality of the Joystick Control Unit JCU) depends to some ex-
tent on settings in the System Software.
10.2.1 Original or Alternative setting
The JCU operates with two different settings – Original and Alternative –
with somewhat different functions for the joystick and the keypad buttons.
For details on the functionality of the JCU with Original and Alternative
setting, see section 6.2.1.
Original/Alternative setting
Step Action
1 Press the ENTER button to enter MENU mode.
2 Select Maintenance …from the Setup menu and press the ENTER button. The Setup –
Maintenance dialog box is displayed.
3 Select MMI Control mode.
4 Use the LEFT/RIGHT navigation buttons to select the desired setting of the JCU –
Original or Alternative.
5 Press the ENTER button to conrm and to exit MENU mode.