Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008 105
9
Hardware installation
This chapter describes the installation of the Ranger HRC MS system.
9.1 Mechanical installation
The top housing (optionally with LRF, GPS and/or DMC units) is moun-
ted on the Pan/Tilt unit when the system is delivered.
NOTE: Do not over torque when tightening screws (max 10 Nm).
9.1.1 JPC2
Ranger HRC MS is a high performance surveillance system, including a
very small eld-of-view optical device. It is important that the system is
mounted and secured on a stable platform; for example a tripod or a rug-
ged tree-top mast.
The mechanical interface of the JPC2 unit is included section 15.6.6.
9.1.2 Pan/Tilt
The Pan/Tilt unit is normally mounted on the JPC2 unit.
Figure 9.1 Pan/Tilt unit and JPC2
1
To Next Page
Loading...
