Ranger HRC™ operator´s manual – Joystick Control Unit
38 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
JCU joystick and keypad – AUTOSCAN mode
Feature Description
Press the
button to go to previous active autoscan point position and then enter
NORMAL mode.
Press the
button to go to next active autoscan point position and then enter
NORMAL mode.
NOTE: This function of the buttons can be disabled in the Setup-Pan/Tilt
dialog box, see section 7.6.1.3.
FRZ Press the FRZ button to freeze/unfreeze the image.
ENTER
No function in AUTOSCAN mode.
6.2.3 PARK mode
The PARK mode is entered by pressing the PRK button in NORMAL,
AUTOSCAN or PROG POSITION mode.
In PARK mode, most keypad buttons are disabled. These are not included
in the table below.
JCU joystick and keypad – PARK mode
Feature Description
Joystick Move the joystick in any direction to return to NORMAL or PROG POSITION mode.
SCN Press the SCN button to return to AUTOSCAN mode.
ENTER
Press the ENTER button to enter MENU mode.
To Next Page
Loading...
