Ranger HRC™ operator´s manual – Technical appendices
Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008 221
15.7 Diagnostic tools
The Ranger HRC MS system has an integrated series of diagnostic tests.
The Setup – Diag tool dialog box is used to run the Focus, FOV, Pan/Tilt,
GPS, LRF and DMC diagnostic tests.
Figure 15.15 Setup – Diag tool dialog box.
Running diagnostic test
Step Action
1 Press the ENTER button to enter MENU mode.
2 Select Maintenance… from the Setup menu and press the ENTER button. The Setup
– Maintenance dialog box is displayed.
3 Select Run diag tool.
4 Use the LEFT/RIGHT buttons to select Yes. The Setup – Diag tool dialog box is dis-
played.
5 Select each function/unit and use the LEFT/RIGHT buttons to select Yes/No to include/
exclude the function/unit from the diagnostic test.
NOTE: It is only possible to run a test of a unit if it is powered on.
6 Press the ENTER button to initiate the diagnostic tests.
Press the CANCEL button to exit.
To Next Page
Loading...
