FLIR Ranger HRC MS - Status Text; Show;Hide System Information

Ranger HRC™ operator´s manual – System software
Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008 45
7.1.1 Status text
A status text is displayed when the function it represents is trigged.
The status text is displayed in the upper left corner of the monitor, except
for “Parked” and “Press PRK > 3 sec”, which are displayed in the center
of the monitor.
The following status texts are available:
• Zooming in
• Zooming out
• Focus far
• Focus near
• Frozen
• Autoscan
• Adjusting
• Connecting
• Saving
• Laser ready (6)
• Searching GPS
• Parked
• Slave Mode On
• Slave Mode Off
• Press PRK > 3 sec
•
Zoom box)
7.1.2 Show/hide system information
In the Setup – Symbology dialog box it is possible to select which informa-
tion to display on the monitor, see section 7.6.1.2.
With the Declutter function, it is possible to temporarily hide the display
information, see section 7.5.1 and 7.5.2.