124 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
10
Basic settings
This chapter provides instructions for basic settings in the System Soft-
ware.
For detailed information about all system settings, see chapter 7.
10.1 Video signal setting
The IR/TV video swap feature is used to control the video signal. The
recommended IR/TV video swap setting depends on the number of con-
nected video monitors.
10.1.1 One monitor
When one video monitor is connected, the VIDEO 1 connector on JPC2
unit J3), Junction Box J6) or Power Box J7) shall be used, see section
9.2.2.
When one monitor is used, the recommended IR/TV video swap setting
is YES. With this setting, the currently active video channel IR or TV) is
always displayed on the video monitor. In this case, the TV/IR button
is used to toggle between TV and IR imaging on the monitor. The Active
channel indicator is always shown.
10.1.2 Two monitors
When two video monitors are connected, both video connectors on the
JPC2 unit, Junction Box or Power Box shall be used.
When two monitors are used, the recommended IR/TV video swap set-
ting is NO. With this setting, each video channel (IR and TV) is always
displayed on its dedicated video monitor. In this case, the TV/IR button
is used to toggle control between the TV and IR monitors. The Active
channel indicator is shown on the active monitor.
To Next Page
Loading...
