Ranger HRC™ operator´s manual – Hardware installation
Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008 123
Figure 9.16 Elevation adjustment screws
Elevation adjustment
Step Action
1 Loosen the two hexagon head bolts a bit, see Figure 9.14 and Figure 9.15.
2 a Raise the IR Camera by loosening the rear elevation adjustment screw and tighten the
front screw, see Figure 9.16.
Lower the IR Camera by loosening the front elevation adjustment screw and tighten the
rear elevation adjustment screw.
2 b Raise the TV Camera by loosening the front elevation adjustment screw and tighten the
rear screw, see Figure 9.16.
Lower the TV Camera by loosening the rear elevation adjustment screw and tighten the
front elevation adjustment screw.
3 When the position of the camera is correct, tighten the two hexagon head bolts, see
Figure 9.14 and Figure 9.15.
4 Tighten the two elevation adjustment screws, see Figure 9.16.
To Next Page
Loading...
