FLIR Ranger HRC MS - JPC2 Configuration

Ranger HRC™ operator´s manual – Hardware installation
Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008 111
1
2
3
4
5
9.2.2.1 JPC2 conguration
With this conguration, the JCU and monitors are connected directly to
the JPC2 unit. The system is powered from the Power Supply unit.
Figure 9.6 JPC2 conguration.
JPC2 conguration
Callout Denomination Part number Connections
1 AC Mains cable - From AC mains supply to Power Supply.
2 Power cable 194 628 From POWER connector (J2) on
JPC2 to Power Supply unit.
3 Video cable 908 929 From VIDEO 1 connector (J3) on
JPC2 to monitor.
NOTE: If only one monitor is used, it shall be connected to the J3 connector.
4 Video cable 908 929 From VIDEO 2 connector (J11) on
JPC2 to monitor.
5 JCU cable 194 612 From JCU connector (J1) on JPC2
to J10 connector on JCU.