FLIR Ranger HRC MS - Adjustments of FOV and Focus; Speed and Dwell Settings

Ranger HRC™ operator´s manual – System operation
146 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
11.4.2.2 Adjustments of FOV and focus
When dening autoscan points, the JCU is used to make adjustments of
eld-of-view and focus, as described in the sections below.
Adjusting FOV and focus
1 a
Press the joystick button < 1
second to go to the next preset eld-of-view. Repeat until
the system is at the desired eld-of-view.
1 b
Use the
and buttons to zoom in/out to the desired eld-of-view.
2 Turn the joystick collar to the left/right to focus near/far.
11.4.2.3 Speed and Dwell settings
The Speed and Dwell settings of the autoscan points are made in the New
pos # and Edit pos # dialog boxes, as described in the sections below.
The Speed setting denes how fast the system shall move to next autoscan
point. The preset speed rates are dened in the Setup – Pan/tilt dialog
box, see section 7.6.1.3.
The Dwell setting denes how long the system shall stay on this autoscan
point before moving on to the next point.
Setting Speed and Dwell
1 In the New pos # or Edit pos # dialog box, use the UP/DOWN buttons to select Speed.
2 Use the LEFT/RIGHT buttons to select the speed setting.
NOTE: Hold down the LEFT/RIGHT button for a while to decrease/increase the
speed with larger increments.
3 Use the UP/DOWN buttons to select Dwell.
4 Use the LEFT/RIGHT buttons to select the dwell time setting.
NOTE: Hold down the LEFT/RIGHT button for a while to decrease/increase the
time with larger increments.
5 Press the ENTER button to conrm.