Ranger HRC™ operator´s manual – System software
Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008 51
7.4.1.2.1 New pos #
The New pos # dialog box is used to dene the Speed and Dwell settings
of new autoscan points.
The New pos # dialog box is opened as a part of the procedures Creating
autoscan lists and Appending autoscan points, see section 11.4.2.4.
Figure 7.8 New pos # dialog box.
New pos # dialog box
Feature Description
Speed The Speed feature is used to select the rate with which the system shall
move to next autoscan point:
• Fast
• Normal
• Slow
The speed rates are set in the Setup – Pan/tilt dialog box, see section 7.6.1.3.
Dwell The Dwell feature is used to set the dwell time (in seconds); that is, how long
the system shall stay on this autoscan point before moving on to the next
point.
To Next Page
Loading...
