Ranger HRC™ operator´s manual – System software
52 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
7.4.1.2.2 Edit pos #
The Edit pos # dialog box is used to edit autoscan point settings.
The Edit pos # dialog box is opened as a part of the procedures Editing auto-
scan points settings and Moving autoscan points, see section 11.4.2.5.
Figure 7.9 Edit pos # dialog box.
Edit pos # dialog box
Feature Description
Speed The Speed feature is used to select the rate with which the system shall
move to next autoscan point:
• Fast
• Normal
• Slow
The speed rates are set in the Setup – Pan/tilt dialog box, see section 7.6.1.3.
Dwell The Dwell feature is used to set the dwell time (in seconds); that is, how
long the system shall stay on this autoscan point before moving on to the
next point.
To Next Page
Loading...
