Ranger HRC™ operator´s manual – Joystick Control Unit
42 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
JCU joystick and keypad – PROG POSITION mode
Feature Description
INV Press the INV button to toggle between White hot and Black hot IR palette.
C Press the C button to quit programming and enter NORMAL mode.
NUC Press the NUC button < 1
second
to perform an Internal NUC.
Press the
NUC button > 1
second
to perform a one-shot auto focus adjustment.
Press the
FCN + NUC buttons < 1
second
to perform an External NUC against the
lens cover.
Press the
FCN + NUC buttons > 1
second
to go to the xed focus position.
Press the
C + NUC buttons < 1
second
to perform an External NUC against the
scene.
Press the
C + NUC buttons > 1
second
to perform a one-shot auto focus
adjustment.
NOTE: The default behavior (above) of the NUC, FCN + NUC and C + NUC but-
tons can be inverted in the Setup- Image dialog box, see section 7.6.1.1.
PRK Press the PRK button < 1
second
to send the system to the home position. If the
PRK button is pressed < 1
second
again when the system is in home position, the
lens cover of the IR Camera will be closed and PARK mode will be entered, see
section 5.1.3.
Press the
PRK button > 1
second
to send the system to the mechanical home posi-
tion, close the lens cover of the IR Camera and enter PARK mode, see section 5.1.3.
NOTE: At system start up, the PRK button has to be pressed for more than
3 seconds to activate the Pan/Tilt unit.
Press the button to zoom in.
Press the
button to zoom out.
Press the button to go to previous active autoscan point position.
Press the
button to go to next active autoscan point position.
If there are no autoscan points, there will be no action.
NOTE: This function of the buttons can be disabled, see section 7.6.1.3.
FRZ Press the FRZ button to freeze/unfreeze the image.
ENTER
Press the ENTER button to open the New pos # dialog box, see section 7.4.1.2.1.
To Next Page
Loading...
