Ranger HRC™ operator´s manual – Hardware installation
Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008 107
Figure 9.3 Holes to use when mounting the cameras
The TV cameras and the Ranger HRC-U camera is mounted with M6 x 20
screws. The Ranger HRC-S camera is mounted with UNC ¼ x ¾ screws.
Mounting the cameras
Step Action
1 Fit the cameras in place, one at the time, on the mounting plates, using the two guiding
pins. It is easiest to start with the front guiding pin and then t the rear pin in place.
2 Thread the four M6 x 20 or UNC ¼ x ¾ screws into the holes that are marked in Figure
9.3. Tighten the screws and ensure that the Pan/Tilt unit is fastened properly.
NOTE: Do not unscrew the other screws in the mounting plate, as that will
destroy the alignment of the camera.
To Next Page
Loading...
