Ranger HRC™ operator´s manual – System operation
138 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
Basic features
Feature ORIGINAL setting ALTERNATIVE setting
Focus
to xed
position
Press the
FCN + NUC buttons > 1 second to go to the xed focus position.
NOTE: If the default setting for the FCN + NUC buttons has been changed
(Setup- Image dialog box, see section 7.6.1.1), the FCN + NUC buttons
shall be pressed < 1 second to go to the xed focus position.
NOTE: The xed focus position is set in the Setup – Image dialog box, see
section 7.6.1.1.
Manual
focus
Turn the joystick collar to the left/right to
focus near/far.
Press the FCN button and turn the
joystick collar to the left/right to focus
near/far.
Freeze
(alt. 1)
Press the FRZ button to toggle between live and frozen image.
Freeze
(alt. 2)
Press the ENTER button to enter MENU mode.
Select
Freeze/Live from the Image menu and press the ENTER button to change
the monitor from live to frozen image or vice versa.
Declutter Select Declutter from the Image menu and press the ENTER button to temporarily
remove the system information from the monitor.
Press the ENTER button to display the system information again
Park
Press the
PRK button < 1 second to send the system to the home position. If the
PRK button is pressed < 1 second again when the system is in home position, the
lens cover will be closed and PARK mode will be entered.
Press the
PRK button > 1 second to send the system to the mechanical home
position, close the lens cover and enter PARK mode.
NOTE: The procedure for dening the home position is described in section
10.3.
To Next Page
Loading...
