Ranger HRC™ operator´s manual – Optimizing the IR Image
Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008 163
Auto focusing
Step ORIGINAL setting ALTERNATIVE setting
1 Verify that the target is in the center of the image.
2 Keep the camera steady when auto focusing.
Press button
NUC > 1 second to perform
a one-shot auto focus adjustment.
Press the joystick button < 1 second
to perform a one-shot auto focus
adjustment.
NOTE: If the default setting for the
NUC button has been changed (
Setup-
Image dialog box, see section 7.6.1.1),
the
NUC button shall be pressed < 1
second to auto focus.
The NUC button can also be used to auto
focus, as for the Original setting.
As an alternative to using the JCU as described above, the IR Camera
menu system can be used:
Auto focusing
Step Action
1 Press the ENTER button to enter MENU mode.
2 Select IR menu from the Setup menu and press the ENTER button. The menu system
of the IR Camera is opened.
3 Select Image and press the ENTER button.
4 Select Focus… and press the ENTER button. The Focus dialog box is displayed.
5 Select Auto.
6 Press the LEFT or RIGHT navigation button to perform a one-shot auto focus adjust-
ment.
7 Press the ENTER button to exit the dialog box.
8 Press the CANCEL button to exit the IR Camera menu system.
To Next Page
Loading...
