Ranger HRC™ operator´s manual – System description
10 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
JPC2 connections
Callout Description
3 Video cable
The Video cable is used to connect a video monitor directly to the JPC2 unit.
The Video cable is connected the VIDEO 1 connector (J3) on the JPC2 unit.
NOTE: The VIDEO 1 connector (J3) corresponds to the J6 connector on the
Junction Box.
4 Video cable
The Video cable is used to connect a video monitor directly to the JPC2 unit.
The Video cable is connected to the VIDEO 2 connector (J11) on the JPC2 unit.
NOTE: The VIDEO 2 connector (J11) corresponds to the J7 connector on the
Junction Box.
5 Ethernet cable
The Ethernet cable is used to connect a LAN switch in an IP network to the JPC2 unit.
The Ethernet cable is connected to the IP connector (J14) on the JPC2 unit.
NOTE: The maximum cable distance between the JPC2 and the LAN switch
is 100 m/ 328 ft.
NOTE: The possibility to connect the system an IP network is an extra option.
The IP connector (J14) is only available if the IP network option has been
chosen.
6 System cable
The System cable is connected to the PTH connector (J15) on the JPC2 unit and to
the X1 connector on the Pan/Tilt unit.
7 Host cable
The Host cable is used when the system is controlled from an external computer.
The Host cable is connected to the NET IN connector (J16) on the JPC2 unit.
NOTE: The possibility to connect an external computer to the JPC2 unit is an
extra option. The NET IN connector (J16) is available on request.
To Next Page
Loading...
