FLIR Ranger HRC MS - Page 64

Ranger HRC™ operator´s manual – System software
54 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
Figure 7.11 Store/recall position list dialog box.
Store/recall position list dialog box
Feature Description
Action The Action feature is used to select which action to apply to the selected
List no. The procedures for storing, recalling and deleting autoscan lists are
described in section 11.4.2.7.
• Store: Stores the currently loaded autoscan list, with the list name dis-
played in the List no item.
• Recall: Recalls and loads the autoscan list with the list name displayed in
the List no item.
• Delete: Deletes the autoscan list with the list name displayed in the List
no item.
List no The List no feature shows the currently selected list name (A, B, C or D) and
the list status.
• Used: Indicates that there is an autoscan list stored with that name, which
can be recalled or deleted.
• Free: Indicates that this list name is free and can be used to store a new
autoscan list.
NOTE: When the autoscan list is stored, the text Saving is displayed on the monitor.
Do not shut down the system until the saving is completed.