Ranger HRC™ operator´s manual – System software
68 Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
Setup – Pan/tilt dialog box
Feature Description
Joystick polarity The Joystick polarity feature is used to select the operational mode of the
joystick.
• Normal: When the operator moves the joystick towards himself, the
Pan/Tilt unit will move downwards.
• Pilot: When the operator moves the joystick away from himself, the
Pan/Tilt unit will move downwards.
P/T-Speed relative
zoom
The P/T-Speed relative zoom feature is used to control the speed of the
Pan/Tilt unit in relation to the current eld-of-view.
• On: The panning and tilting speeds are lower for narrower elds-of-view.
• Off: The panning and tilting speeds are the same for all elds-of-view.
Left/Right scan-
point selection
The Left/Right scanpoint selection feature is used to control the function of
the
and
buttons on the JCU.
• On: The
and
buttons are used to move the system to the previ-
ous/next autoscan point. This is the default setting.
• Off: The
and
buttons can not be used to move the system to the
previous/next autoscan point.
To Next Page
Loading...
