”
Menu #3 “Drive Monitoring” (
#ope
) is used to monitor the running status during maintenance and test running.
The display items for “Drive Monitoring” are listed in Table 3.4-3. Figure 3.4-2 shows the menu transition in “Drive
Monitoring.”
Figure 3.4-2 Menu Transition in Menu #3 “Drive Monitoring”
Basic key operation
To monitor the running status in “Drive monitoring,” set function code E52 to “2” (Full-menu mode) beforehand.
(1) Turn the inverter ON. It automatically enters Running mode in which you press the
key to switch to
Programming mode. The function selection menu appears. (In this example,
*fnc
is displayed.)
(2) Use the and keys to display “Drive Monitoring” (
#ope
).
(3) Press the key to proceed to a list of monitoring items (e.g.
3_00
).
(4) Use the and keys to display the desired monitoring item, then press the key.
The running status information for the selected item appears.
(5) Press the key to return to the list of monitoring items. Press the key again to return to the menu.
To Next Page
Loading...
