Fuji Electric FRENIC-Ace series - Page 297

5.3 Description of Function Codes
5-127
FUNCTION CODES
Chap 5
• Data setting range: E30: 0.0 to 10.0 (Hz), E29: 0.01 to 10.00 (s)
The operation timings of each signal are as shown below.
Frequency/speed
Command
Run command
Frequency arrival “FAR”
Frequency arrival 3 “FAR3”
Detected speed
(output frequency)
Arrival range
Speed command=0
Arrival range
Frequency setting
Reference frequency (1)+E30
Reference frequency (1)
Reference frequency (1)-E30
Reference frequency (2)+E30
Reference frequency (2)
Reference frequency (2)-E30
Frequency setting change
Output frequency
Frequency arrival “FAR”
Frequency arrival 2 “FAR2”
Frequency arrival delay E29
Frequency
arrival delay
E29