5.3 Description of Function Codes
5-134
E52
Keypad (Menu display mode)
E52 provides a choice of three menu display modes for the standard keypad as listed below.
E52 data Menu display mode Menus to be displayed
0 Function code data editing mode Menus #0, #1 and #7
1 Function code data check mode Menus #2 and #7
2 Full-menu mode Menus #0 through #7
E52 specifies the menus to be displayed on the standard keypad. There are eight menus as shown in the table
below.
Menu # LED monitor shows:
Function Display content
0
*.fnc
Quick setup Quick setup function code
1
!.f__
Data setting F to o F to o group function code
2
".rep
Data check Modified function code
3
#.ope
Operation monitor Operation status indication
4
$.i_o
I/O check DIO, AIO status indication
5
%.che
Maintenance Maintenance information indication
6
&.al
Alarm information Alarm information indication
7
' cpy
Data copy Data copy function (only optional keypad )
8
( des
Destinations Destinations setting
For details of each menu item, refer to Chapter 3 “OPERATION USING THE KEYPAD.”
E54
Frequency detection 3 (level) (refer to E31)
For details, refer to the description of E31.
E55, E56
Current detection 3 (level and timer)
For details, refer to the description of E34.
To Next Page
Loading...
