2.3 Attachment and Connection of Keypad
2-58
(4) Fix the keypad to the cabinet using 2 keypad rear cover fixing screws. (Refer to Figure 2.3-7) (tightening
torque: 0.7 N•m(6.2lb-in))
Figure 2.3-7 Attachment of the Keypad
(5) Connect the extended cable for remote operation (CB-5S, CB-3S, CB-1S) or the commercially available LAN
cable (straight) to the keypad RJ-45 connector and the inverter main body RJ-45 connector (modular jack).
(Refer to Figure 2.3-8.)
Figure 2.3-8 Connection of the Extension Cable or the Commercially Available LAN Cable
between the Keypad and the Inverter Main Body
• Do not connect the inverter to PC LAN ports, Ethernet hubs, or telephone lines. The inverter and the
connected instrument may be damaged.
Risk of fire and risk of accidents exist.
■ Operating remotely, on the hand
Connect following the procedure (5) in “ Attachment to the cabinetAttachment to the cabinetAttachment to the
cabinetAttachment to the cabinet”.
To Next Page
Loading...
