3.2 Overview of Operation Modes
3-4
Figure 3.2-2 illustrates the transition of the LED monitor screen during Running mode, the transition between menu
items in Programming mode, and the transition between alarm codes at different occurrences in Alarm mode.
Figure 3.2-2 Transition between Basic Screens in Individual Operation Mode
(*1) The speed monitor allows you to select the desired one from the speed monitor items by using function code
E48.
(*2) Applicable only when PID control is active (J01 = 1, 2 or 3).
(*3) The analog input monitor can appear only when the analog input monitor function is assigned to one of the
analog input terminals by one of function codes E61 to E63 (= 20).
(*4)
0
appears under the V/f control.
(*5) The Timer screen appears only when the timer operation is enabled with function code C21 (C21 = 1).
(*6) Applicable only when the full-menu mode is selected (E52 = 2). When a remote keypad with USB is
equipped,
'cpy
is displayed.
To Next Page
Loading...
