Figure 298: Removing the power cable clamp
▶
Using a small pair of combination pliers, press together the hooks on the
power cable clamp (1) and remove it from the defective system board (2).
Installing the new system board
▶
If applicable, install the iRMC microSD card, see "Installing the iRMC
microSD card" on page
428.
▶
If applicable, install the TPM, see "Installing the TPM" on page 418
.
▶
Check the settings on the new system board, see "Onboard settings" on
page 515.
▶
Insert the system board by holding it at a slight angle. Slide the connectors
into the I/O panel, see Figure 297.
▶
Lower the system board carefully into the chassis.
▶
Adjust the system board. If necessary adjust the position of the system
board with a gentle twisting motion (orange circles in Figure 296 show the
centering bolts).
▶
Fasten the system board with the eight screws, see Figure 296.
System board and components
TX1330 M4 Upgrade and Maintenance Manual 455
To Next Page
Loading...
