FUTABA T12K

160
<Model Menu (Airplane/Glider/Multirotor Functions)>
When setting a rate selection switch, move
the cursor to the switch item and push the
RTN button to access the selection screen.
SelecttheswitchandsetitsONdirection.
(AlwaysONat"--"setting)
*For a description of the switch selection method, see the
description at the back of this manual.
●Gyro type selection
Move the cursor to the gyro type selection
item and push the RTN button to switch to
thedatainputmode.Selectthegyrotype
byscrollingthePushdial.
 [GY]:WhenaFutabaGYAgyroisused
 [NORM]:Whenusingsomethingotherthan
FutabaGYAgyroisused.
 PushtheRTNbuttontochangethegyrotype
and return to the cursor mode.
*When a Futaba GYA gyro is used and [GY] type is selected,
the sensitivity set value is directly read in both AVCS and
NORM modes.
●Operation mode selection (GYA gyro)
Move the cursor to the operation mode
selection item and push the RTN button to
switchtothedatainputmode.Selectthe
operationmodebyscrollingthePushdial.
 [AVCS]:AVCSmode
 [NORM]:Normalmode
 PushtheRTNbuttontochangetheoperation
mode and return to the cursor mode.
●Sensitivity setting
Move the cursor to the sensitivity icon and
push the RTN button to switch to the data
input mode.
 AdjustthesensitivitybyscrollingthePushdial.
 Initialvalue:0%
 Adjustmentrange:0~100%
*When the RTN button is pushed for one second, the
sensitivity is reset to the initial value.)
 PushtheRTNbuttontoreturntothecursor
mode.
(Example) Setting three axis using a GYA440 and GYA441 (2)
●Wingtype:2fuselage-mountedaileronservosselected.
●Set
5CH → GYRO
(GYA441AIL),
7CH → GYRO2
(GYA441ELE),
8CH → GYRO3
(GYA440RUD),
CTRL
and TRIM → [--]
:attheFunctionmenuoftheLinkagemenu.
●GYROsettingoftheModelmenu.
*Set so that Rate 1 is turned on at the back position of switch E and Rate 3 is turned ON at the front position. Since
switch E is turned OFF at the center, Rate 2 remains [INH].
Receiver
Rudder servo
Elevator servo
GYA440
GYA441
GYA441
Aileron servo
S.BUS/S.BUS2 port
GAIN 0％
AVCS
NORMAL
When AVCS is used, we
recommend that the
sensitivity CH be set to
the 3-position.
Rate GYRO GYRO ２ GYRO ３ TYPE ACT/INH SW
#1 AVCS : 60% AVCS : 60% AVCS : 60% GY OFF/ON SE
#2 INH
#3 NORM : 60% NORM : 60% NORM : 60% GY ON/OFF SE