FUTABA T12K

182
<Functions of Model Menu (Helicopter Functions)>
Setting method
●Gyro type selection
 Movethecursortothegyrotypeselection
itemandpushtheRTNbuttontoswitchto
thedatainputmode.Selectthegyrotype
byscrollingthePushdial.
 [GY]:WhenaFutabaGYgyroisused
 [NORM]:Whenanon-FutabaGYgyrois
used.
 PushtheRTNbuttontochangethegyrotype
andreturntothecursormode.
*When a Futaba GY gyro is used and [GY] type is selected,
the sensitivity set value is directly read in both the AVCS
and NORM modes.
●Operation mode selection (GY gyro)
 Movethecursortotheoperationmode
selectionitemandpushtheRTNbuttonto
switchtothedatainputmode.Selectthe
operationmodebyscrollingthePushdial.
 [AVCS]:AVCSmode
 [NORM]:Normalmode
 PushtheRTNbuttontochangetheoperation
modeandreturntothecursormode.
●Sensitivity setting
 Movethecursortotherateitemandpush
theRTNbuttontoswitchtothedatainput
mode.
 AdjustthesensitivitybyscrollingthePushdial.
 Initialvalue:80%
 Adjustmentrange:0~100%
*When the RTN button is pushed for one second, the
sensitivity is reset to the initial value.)
 PushtheRTNbuttontoreturntothecursor
mode.
●Fine tuning VR settings
 Movethecursortothe[--]itemandpushthe
RTNbuttontoaccesstheselectionscreen.
Selectthecontrol.
*For a description of the switch selection method, see the
description at the back of this manual.
 Movethecursortotherateitemandpush
theRTNbuttontoswitchtothedatainput
mode.
 AdjustthetrimratebyscrollingthePushdial.
 Initialvalue:0%
 Adjustmentrange:-20~+20%
*When the RTN button is pushed for one second, the
sensitivity is reset to the initial value.)
 PushtheRTNbuttontoreturntothecursor
mode.
<EXAMPLE>Rudder gyro gain is changed with
a switch (SF) irrespective of condition.
Generally,gainisinterlockedwithcondition
andchangesarate.
Howtochangetworatesinthesame
conditionhere.
1.Select[GYRO]attheModelmenuand
accessthesetupscreenshownbelowby
pushingtheRTNbutton.
2.Movethecursortothe[COND]itemand
pushtheRTNbuttontoaccesstheselection
screen.Selectthe[SW].PushtheRTNbutton
toreturntothecursormode.
3.#numbershowsthepresentswitchstate.In
thestateof#1acursorismovedto[--]and
RTNispushed.
4.[SF]ischosenby[H/WSELECT]andthena
topisturnedON.
5.[TYPEGY]and[RATE]ofastateof"#1=SF
top"aresetup.
6.Itisasetupof"#2".Movethecursorto
the[#1]itemandpushtheRTNbuttonto
accesstheselectionscreen.Selectthe[#2].
PushtheRTNbuttontoreturntothecursor
mode.
SF : Top = #1
●
Thenumber
ofaSWstate