Aileron
Elevator
Rudder
StickStick
The interior of your transmitter should look like the gure above. Use a small Phillips screwdriver
to rotate the adjusting screw of each stick for the desired spring tension. Increase tension by twisting
clockwise, decrease tension by twisting counter clockwise. When you have found the desired stick
tension, reattach the rear cover, install the four screws, then reinstall the battery and cover.
You can also adjust
how quickly a stick
returns to neutral.
+ screw is clockwise.
Stick tension maximum Stick tension minimum
+ screw is counter-clockwise.
Do not over-loosen
the screw or the
screw will touch
the case.
Do not over-loosen
the screw or the
screw will touch
the case.
*The screw will touch the case.*The screw will touch the case.
To Next Page
Loading...
