If the receiver's voltage does not display on the transmitter
◆ When the receiver has the transmitter's ID in memory, a link is established and normal
operation is allowed.
◆ When the transmitter has the receiver's ID in memory, a link is established and
telemetry functions are usable.
The transmitter stores receiver IDs by model; thus, if it does not have a particular
receiver model ID stored in memory or has a different receiver ID stored, telemetry
functions will be unusable. However, the device is operable as long as the receiver has
the transmitter's ID stored in memory.
When setting up a new model, before using it, rst
establish a link with the receiver that will be used
with it.
Link
Operable
Tx ID: xxxxxx2
stored
Telemetry usable
Telemetry usable
Receiver ID: xxxxxx1
stored for Model 1
Link of model 1
Transmitter switched to Model 2 and
link reestablished
Because receiver IDs will be stored
in the memory of each transmitter
model, it is unnecessary to
reestablish a link once the receiver
ID has been stored in memory for
a given model.
Device is operable if receiver
has transmitter's ID stored in
memory
Telemetry functions unusable because
Model 2 does not have receiver's ID
stored in memory.
Tx ID: xxxxxx2
stored
Rx ID: xxxxxx1Tx ID: xxxxxx2
Link
Rx ID: xxxxxx1
Rx ID: xxxxxx1
Model 1: Receiver ID: xxxxxx1
Model 2: Receiver ID: ---------
Model 3: Receiver ID: ---------
Model 1: Receiver ID: xxxxxx1
Model 2: Receiver ID: ---------
Model 3: Receiver ID: ---------
Model 1: Receiver ID: xxxxxx1
Model 2: Receiver ID: xxxxxx1
Model 3: Receiver ID: ---------
Model 1 → Model 2
To Next Page
Loading...
