FUTABA T12K - Page 52

52
<Receiver and Servo Installation>
5. Throttle/Pitch curve setting
This function adjusts the throttle or pitch
operation curve in relation to the movement of the
throttle stick for each condition.
<Throttle curve setting example>
Activate the throttle curve of each condition with
the condition select switch.
●Normalcurveadjustment
Normalcurvecreatesabasicthrottlecurve
centerednearhovering.Thiscurveisadjusted
togetherwiththepitchcurve(Normal)sothatthe
enginespeedisconstantandup/downcontrolis
easiest.
●Idleupcurveadjustment
ThelowsideThrottlecurvecreatesacurve
matchedforaerobatics(loop,roll,3D,etc.).
●Throttleholdcurveadjustment
Conrmthattherateoftheslowestposition(0%)of
thestickis0%(initialsetting).
<Example of pitch curve setting>
Activate the pitch curve of each condition with
the condition select switch.
●Pitchcurve(Normal)
Makethepitchathoveringapproximately+5
º
~6
º
.
Setthepitchathoveringwiththestickpositionat
the50%pointasthestandard.
*Stability at hovering may be connected to the throttle curve.
Adjustment is easy by using the hovering throttle function
and hovering pitch function together.
●Pitchcurve(Idleup1)
Theidleup1pitchcurvefunctioncreatesacurve
matchedtoairborneight.
Setto-7
º
~+12
º
asstandard.
●Pitchcurve(Idleup2)
Thehighsidepitchsettingislessthanidleup1.
Thestandardis+8
º
.
●Pitchcurve(Hold)
Atautorotation,usethemaximumpitchatboth
thehighandlowsides.
[Pitchanglesettingexample]
Throttlehold:-7
º
~+12
º
4. Servo Connection
Connect the throttle rudder, aileron, elevator,
pitch, and other servos in accordance with the
kit instruction manual. For a description of the
connection method, see "Receiver and Servos
Connection".
Note: The channel assigned to each function
can be checked at the Function menu of the
Linkage Menu.
●Ifthedirectionofoperationoftheservo
isincorrect,usetheReversefunctionof
theLinkageMenu.AlsousetheswashAFR
functioninotherthantheH-1mode.
●Adjustthedirectionofoperationofthegyro.
(Gyrosidefunction)
●Connectthethrottlelinkagesothatthe
carburetorcanfullycloseatfulltrimthrottle
cut.
●Adjusttheneutralpositionatthelinkageside
andnetunewiththeSub-Trimfunctionand
EndPointfunction.Toprotectthelinkage,
alimitpositioncanalsobesetwiththeEnd
Pointfunction.
●Swashplatecorrection(ExceptH-1mode)
*If any interactions are noticed, for a description of the
linkage correction function, please refer to the SWASH
function.