(Note) When this parameter is large, the current consumption increases.
• Buzzer
When a servo power is turned on before a transmitter is connected, a buzzer sounds at 2.5Hz from the
servo.
(It is not unusual for a servo buzzer to continue, even if a transmitter is disconnected, if the signal from the
servo is not normal. )
If the transmitter is turned off before the servo power supply a buzzer sounds at 1.25Hz for the servo
power supply end failure alarm.
(
Do not insert or remove the servo connector while the receiver power is ON. A buzzer may
sound by incorrect recognition.
)
＊
Buzzer sound is generated by vibrating the motor of a servo.
Sounding a buzzer consumes current and produces heat. Do not operate the unit or allow a buzzer to
sound for a long time.
To Next Page
Loading...
