FUTABA T12K - Page 82

82
<Functions of Linkage Menu>
Camber/Motor/Buttery control setting (glider)
*Camber/motor/buttery function control can be changed for
each condition.
 Camber,motororbutterflycontrolgroup/
singlesettingisperformedatthefunction
setupscreen.  
"G":Group(commontoallconditions)
"S":Single(setforeachcondition)
Trim setting
 Movethecursortothe"TRIM"itemofthe
channelyouwanttochangeandpushthe
RTNbutton.
*The trim setup screen is displayed.
 Thefollowingitemscanbesetatthetrim
setupscreen:
Trim selection
 Movethecursortothetrim,lever,etc.you
wanttosetandpushtheRTNbutton.
*The setting can be changed.
Trim rate setting
 Movethecursortothe[RATE]itemandpush
theRTNbuttontoswitchtothedatainput
mode.
 SetthetrimratebyscrollingthePushdial.
 Initialvalue:+30%
 Adjustmentrange:-150~+150%
(When the RTN button is pushed for one second, the trim rate
is reset to the initial value.)
 PushtheRTNbuttontoendadjustmentand
returntothecursormode.
Trim mode selection
 Movethecursortothe[MODE]itemand
pushtheRTNbuttontoswitchtothedata
inputmode.
 SelectthetrimmodebyscrollingthePush
dial.Aconrmationmessageappears.Push
theRTNbuttontochangethemode.(To
terminateinputandreturntotheoriginal
state,pushtheS1button.)
 [NORM]:Normalmode.Normaltrim(parallel
shifttrim)operation.
 [ATL]:ATLoperationmode.Maximum
changenearidleorlow-stickposition,
normallyusedwiththrottletrim.Itisalso
possibletoreversethetravel.
*[NORMAL]/[REVERSE] selection is possible in "ATL"
mode.
Throttle trim (helicopter only)
* The throttle trim in conditions other than "normal" condition
can be inhibited.
 Whenotherthannormalconditionis
selected,movethecursortothrottletrimon
thefunctionsetupscreenandpushtheRTN
buttonfor1second.
*When "X" is displayed, THR trim is inhibited in conditions
other than normal condition.
Channel replacement
 Movethecursortothechannel#youwant
toreplaceandpushtheRTNbuttontoswitch
tothedatainputmode.
 Selectthedestinationchannel#byscrolling
thePushdial.Aconfirmationmessage
appears.PushtheRTNbuttontoreplacethe
channel.(Toterminateinputandreturnto
theoriginalstate,pushtheS1button.)