FUTABA T12K

93
<Functions of Linkage Menu>
Subtrim setting procedure
Subtrim can be set on the last page of the swash
setting screen.
*The sub-trim value set here is reflected at sub-trim of the
linkage menu.
Pitch adjustment procedure
The pitch adjustment function can be used on the
last page of the swash setting screen.
1.Callthelastpageoftheswashsetting
screen.
2.Whenthecursorismovedtoapitch
adjustmentbuttonandtheRTNbuttonis
pushed,thecorrespondingpitchisoutput.
* In the pitch adjustment mode an * is displayed at the left
side of the current output setting button.
*If the cursor is moved to another button and the RTN button
is pushed during pitch adjustment, the pitch adjustment
mode is deactivated.
 Functiondetailsareasfollows:
Button Function
High Highpitchxedoutputmode
Neutral Neutralpitchxedoutputmode
Low Lowpitchxedoutputmode
Moving Cyclicpitchoutputmode
*The cyclic pitch speed can be set with the button at the right
side of the “Moving” button.
 Settingrange:1to100
*When the set value is large, motion becomes fast and when
the set value is small, motion becomes slow.