UCM6100 Series User Manual
Version 1.0.18.13
Static Agents limitation:
To guarantee a high level of audio quality with the call queue feature, UCMs will limit the number of static agents
allowed to be assigned depending on the UCM model used. If the user attempts to configure the number of static
agents to be more than the maximum allowed number, a warning message will appear.
Figure 156: Static Agents limitation
If enabled, the UCM6100 will report (to the agent) the duration of time of the call
before the caller is connected to the agent. The default setting is "No".
If enabled, the UCM will replace the caller display name with the Call Queue name
so that the caller knows the call is incoming from a Call Queue.
Enable feature codes option for call queue. For example, *83 is used for “Agent
Pause”
If enabled, the configured PIN number is required for dynamic agent to log in. The
default setting is disabled.
Configure the call destination for the call to be routed to if no agent in this call
queue answers the call.
Go to “Agents” Tab and Select the available users to be the static agents in the
call queue. Choose from the available users on the left to the static agents list on
the right. Click on to choose. And use UP and Down arrow to select the
order of the agent within the call queue.
To Next Page
Loading...
Need help?
General
