FAX Sending
Besides the support of Fax machines, The UCM6100 supports also sending Fax via Web GUI access. This
feature can be found on Web GUI→Value-added Features→Fax Sending page. To send fax, pre-setup for
analog trunk and outbound route is required. Please refer to [ANALOG TRUNKS], [VOIP TRUNKS] and [Outbound
Routes] sections for configuring analog trunk and outbound route.
After making sure analog trunk or VoIP Trunk is setup properly and UCM6100 can reach out to PSTN numbers
via the trunk, on Fax Sending page, enter the fax number and upload the file to be faxed. Then click on “Send”
to start. The progress of sending fax will be displayed in Web GUI. Users can also view the sending history is in
the same web page.
Figure 176: Fax Sending in Web GUI
After that you can see the ongoing sending operation on the progress bar.
Figure 177: Fax Send Progress
To Next Page
Loading...
