The 2nd number indicates the nth iteration of the weekday: (1st Sunday,
3rd Tuesday…). Normally 1, 2, 3, 4 are used. If 5 is used, it means the last
iteration of the weekday.
The 3rd number indicates weekday: 0,1,2,..,6 ( for Sun, Mon,
Tues, ... ,Sat).
Therefore, this example is the DST which starts from the First Sunday of
April to the 1st Sunday of November.
Set Time Manually
To manually set the time on the UCM6100, go to Web GUI→System Settings→Time Settings→Set Time
Manually. The format is YYYY-MM-DD HH:MM:SS.
Figure 45: Set Time Manually
----------------------------------------------------------------------------------------------------------------------------- ----------------------
Note:
Manually setup time will take effect immediately after saving and applying change in the Web GUI. If users would
like to reboot the UCM6100 and keep the manually setup time setting, please make sure "Remote NTP Server",
"Enable DHCP Option 2" and "Enable DHCP Option 42" options under Web GUI→Settings→Time
Settings→Auto Time Updating page are unchecked or set to empty. Otherwise, time auto updating settings in
this page will take effect after reboot.
--------------------------------------------------------------------------------------------------------------------------------------------------
NTP Server
The UCM6100 can be used as a NTP server for the NTP clients to synchronize their time with. To configure the
UCM6100 as the NTP server, set "Enable NTP server" to "Yes" under Web GUI→System Settings→Time
Settings→NTP Server. On the client side, point the NTP server address to the UCM6100 IP address or host
name to use the UCM6100 as the NTP server.
To Next Page
Loading...
Need help?
General
