• Added pickup group feature. [Table 87: UCM6100 Feature Codes]
• Added PSTN detection instructions for "Auto Detect" and "Semi-auto Detect". [PSTN Detection]
• Added "Auth ID" option for SIP register trunk configuration. [Table 53: Create New SIP Trunk]
• Added LDAP sync options for peer SIP trunk. [Table 53: Create New SIP Trunk]
• Changed the default setting of outbound route "Privilege Level" from "Internal" to "International" to avoid
potential misconfiguration and security risk.
• Added DISA and Fax to IVR key press event options. [IVR Configuration Parameters]
• Added "Min Message Time" option in voicemail settings. [Table 68: Voicemail Settings]
• Added Fax setting samples. [Fax]
• Added DISA support for inbound route and IVR.
• Added Event List support to monitor local extensions and remote extensions. [BLF AND EVENT LIST]
• Added feature code *0 for "Disconnect". [Table 87: UCM6100 Feature Codes]
• Added feature code *8 for "Pickup Extension" in pickup group feature. [Table 87: UCM6100 Feature Codes]
• Added "Record Prompt" and "Custom Name of Pickup Group" options in internal options. [Table 91: Internal
Options/General]
• Added warning information for "Allow Guest Call" option to avoid potential security risk caused by
misconfiguration. [Table 102: IAX Settings/General]
• Changed reset mode to two mode "User Data" and "All".
Firmware Version 1.0.1.22
• This is the initial version.
To Next Page
Loading...
Need help?
General
